Packages
Honey Plan Non-Member Maintenance $129.95 saving start at 620.00 Annually
- Function Meter test Compressor Amperage Clean Condenser unit with Outdoor Coil Cleaner Vacuum & Flush Condensate Drainline Oversee Armaflex on the refrigerant copper line.
- Voltage meter electrical Inspection Read Life level on the capacitor(S) levels on the unit.
- Inspect the Contractor’s function and Conditions. Test outside defrost boards.
- Meter analysis of fan motor voltage Inspects refrigerant pressures on the unit.
- Compute Sub-cooling and Superheating. Check air Filters. Measure split air float check.
- Meter Analysis Blower Motor Voltage Observe the life-spanned and cleanliness of Evaporator Coils Analyze the condensate drain pan.
- Exam and configure the safety float switch.
- Run the system in heat mode.
- Exam with a voltage meter the inside circuit board Assess static Air Pressure Examine air ducts for leaks and cleanliness.
- Examine the Plenum for leaks and cleanliness.
- Evaluate room temperatures at each vent with a laser temperature gun.
- Tune up and Clean a Year
- Free Service Calls
- Same Day Emergency Service calls
- No repair Guarantee
- Annual Airflow analysis
- 10% discount
Honey Comb Commercial Maintenance Plan For Split systems $ 199.98 Saving start at $200.00 add 10% off repairs on site
Record and report all data to owner Fall and winter Inspection (prior to the heating season) shall include, but is not limited to the following:
- Check and clean or replace filters
- Check and adjust thermostat
- Check and adjust all safety controls
- Lubricate moving parts as applicable
- Check belts and adjust tension, if needed
- Check and/or replace filters
- Check fan control
- Record temperature rise
- Check complete heating cycle
- Check electrical wiring connections and insulation
- Record and report all data to owner $500.00 off new Unit
Spring and Summer Inspection (prior to the cooling season) shall include, but is not limited to the following
- Check and clean or replace filters
- Connect gauges and check operating pressures
- Record liquid line and suction line pressures
- Check for signs of refrigerant leaks
- Check all motor amperage draws
- Record temperature differential across evaporator coil
- Check evaporator suction line temperature
- Lubricate moving parts as applicable
- Check belts and adjust tension, if needed
- Check pressure cut-out settings
- Check start capacitors and potential relays, if applicable
- Check compressor omns
- Check all wiring and wiring connections
- Clean condenser coils
- Check condensate drain operation
- Supply and place biocide tablets in condensate pans
Bee Hive Plan Member Maintenance $240.95 Saving start at $1151.00 Annually
- Function Meter test Compressor Amperage Clean Condenser unit with Outdoor Coil Cleaner Vacuum & Flush Condensate Drainline Oversee Armaflex on the refrigerant copper line.
- Voltage meter electrical Inspection Read Life level on the capacitor(S) levels on the unit.
- Inspect the Contractor’s function and Conditions.
- Test outside defrost boards.
- Meter analysis of fan motor voltage Inspects refrigerant pressures on the unit.
- Compute Sub-cooling and Superheating. Check air Filters.
- Measure split air float check.
- Meter Analysis Blower Motor Voltage Observe the life-spanned and cleanliness of Evaporator Coils Analyze the condensate drain pan.
- Exam and configure the safety float switch.
- Run the system in heat mode.
- Exam with a voltage meter the inside circuit board Assess static Air Pressure Examine air ducts for leaks and cleanliness.
- Examine the Plenum for leaks and cleanliness.
- Evaluate room temperatures at each vent with a laser temperature gun.
- Tune up and Clean Twice a Year
- Free Service Calls
- Up to 4 LBS. Refrigerant a year
- Same Day Emergency Service calls
- 48-hour Repair Guarantee
- Annual Airflow analysis
- 20% Discount on Repairs
- $500.00 on new unit
Bumble Bee Commercial Maintenance For Rooftop Units. $ 324.98 Yearly or Twice a Year Savings start at $350.00 add 10% off repairs on site
- Clean Equipment Exterior
- Flush and Vacuum Drain Line Lubricate All Moving Parts Where Applicable
- Change or Wash Customer-supplied Filter
- Brush Out Electrical Cabinet
- Check System for Proper Refrigerant
- Charge Check Compressor and Fan Amperages
- Check Capacitors
- Check Contactor Points
- Check All Service Valves and Caps
- Check Thermostat Operation and Mounting
- Check Blower Amperages
- Check Heat Strip Amperages
- Check Evaporator Coil for Build Up
- Check All Electrical Connections
- Check Temperature Split
- Check Float Switch Operation
- Check Overall System Performance
- Check Blower Wheel for Build Up Preferred Scheduling
- Check and Clean Condenser Coil
- Check and Clean Condenser Fan Clean and Dust Return Air Grills Micro Ban (4x per year) $ 500 Off New AC Systems
Preventative Maintenance Plan Changes
- No Charge for mini-split maintenance.
- There is a 5-day grace period for any service call, meaning no service call fee if an issue occurs within 5 days of service.
- Filters are changed every 4 to 5 weeks, and quarterly maintenance is done at the end of the third month.
- Major Repairs: Includes a 20% discount on Freon charges for major repairs.
Bumble Bee Commercial Maintenance For Rooftop Units:
- 12 visits per year, which means monthly maintenance checks.
- The plan automatically renews until the customer cancels it.
- $55.00 per month for the maintenance plan.
- Customers get a 10% discount on other HVAC jobs.
Details of Service
- Monthly filter changes using 1 to 2-inch pleated filters.
Quarterly maintenance includes:
- Cleaning of condensation pumps and drain lines.
- Cleaning and inspection of the internal drain pan.
- Inspection of electrical components in the blower motor and air handler.
- Checking condenser electrical components.
- Semi-annual condenser coil cleaning.
- No Charge for mini-split maintenance.
- 5-day service call grace period, so there will be no fee for service calls during this period.
- Filters are changed every 4 to 5 weeks, and quarterly maintenance is completed in the final two weeks of the third month.
- Major Repairs: A 50% discount on Freon charges and a 10% discount on repairs.
Honey Comb Commercial Plan for Split Systems:
- 12 visits per year, one every month.
- Auto-renewing unless canceled by the customer.
- $45.00 per month for this plan.
- 10% discount on other HVAC jobs.
Details of Service
- Monthly filter changes using 1-inch to 2-inch pleated filters.
Quarterly maintenance includes:
- Cleaning of condensation pumps and drain lines.
- Cleaning and inspection of the internal drain pan.
- Electrical inspection of blower motors and air handler components.
- Inspection of condenser electrical components.
- Semi-annual condenser coil cleaning.
